AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Install wifidog on windows3/11/2024 If you are not sure, you can run the command “ifconfig”, and find the them from the result. Internal NIC stands for the one which is connected to your local network. External NIC stands for the network interface which is connected to the Internet. You will be required to enter the External NIC and the Internal NIC. Then follow the prompts to complete the setup.Įspecially, the Hotspot ID you need to input is the one (NOT the Hotspot Name) that stands for the Hotspot you created in the Web Control Panel. usr/local/hsbuilder/hsbuilder_setup4openwrt.sh setup Set it up by running the following commands :Ĭd / tar -zxf /root/ Configure the HotSpot Builder Utility packageĬonnect a PC to your wireless router, and SSH into your wireless router from the PC. Remember it, it will be used in next steps.ģ. You can find out the Hotspot ID generated of the Hotspot you just created. Follow the instructions and fill all the right items, click save. Ĭlick “My Hotspots”, and then click “Create a New Hotspot” in the page displayed. ![]() Login into the Web Control Panel by accessing. Create your Hotspot in the Web Control Panel Make your wireless router connected to the Internet firstly.Ĭonfigure and enable wireless network (create an available AP).Ģ. You can try to install Wifidog by running the following command: ![]() A wireless router with OpenWrt installed (typically Linksys WRT54G series) Installation Guide of HotSpot Builder Utility
0 Comments
Read More
Leave a Reply. |